Me as 3D printed action figure joint setup

Here you can see the setup of the joint system of the 3D model for my latest 3D printed action figure. Below the renders are some pictures of the final printed and hand painted figure. Everything was modeled in MODO including the head and the joints. Some additional work was done in Netfabb to make all the joints work. The figure has over 35 points of articulation and is about 18 cm  (7 inch) high. It is also the first time I used ball joints in an action figure. They are a little bit more wobbly then other joints but they allow for a great range of motion. This is by far my most articulated figure yet. The figure was printed on a Stratasys Mojo in ivory material and then hand painted by me.